From 30f268f8a13209f720dc4879e1dde8e8319ebcb8 Mon Sep 17 00:00:00 2001 From: Thomas Bushnell Date: Wed, 16 Apr 1997 19:53:41 +0000 Subject: Fri Apr 11 14:21:29 1997 Thomas Bushnell, n/BSG * SETUP: Comment out frobbing of BOOT_DEV; grub does that on it's own now. * INSTALL-GRUB-MBR: Delete file. * Makefile (dist-files): Omit INSTALL-GRUB-MBR. (install-dist): Likewise. * menu.lst (title): Replace install entries with new versions. * INSTALL-binary (STEP IV): Revised instructions to correspond to new reality, with Grub 0.4. --- release/INSTALL-binary | 22 +++++++++------------- 1 file changed, 9 insertions(+), 13 deletions(-) (limited to 'release/INSTALL-binary') diff --git a/release/INSTALL-binary b/release/INSTALL-binary index 25a3f932..745ff4a5 100644 --- a/release/INSTALL-binary +++ b/release/INSTALL-binary @@ -126,17 +126,12 @@ and you may notice that pipes don't work. In order to set up the translators for this to be a fully functional Hurd system, say - /bin/sh /SETUP disk - -where `disk' is the name of the disk to install the boot block on, -without partition name, for example `sd0' or `hd0'. (If you give no -arg, it will ask you for the device to install the boot block on in -case you forgot. If you really don't want a boot block, just hit RET -when it asks.) + /bin/sh /SETUP This will set up some initial translators so that the system runs -normally, and then offer to reboot the system. When it comes back up, -boot it single-user again, so that you can do step V. +normally, and then offer to reboot the system. When you get to the +GRUB menu, do step V. + NOTE: Do NOT RUN BSD FSCK on a Hurd FFS! @@ -157,10 +152,11 @@ NOTE: Do NOT RUN BSD FSCK on a Hurd FFS! STEP V: -Now boot from the floppy again. This time, select the "grub install" -option. (If your disk isn't known as hd0 to grub, then you will need -to edit the commands accordingly.) Reset your PC and take the floppy -disk out of the drive. The hard disk should now boot successfully. +Now boot from the floppy again. This time, select the option to +install grub from the floppy. (If your disk isn't known as hd0 to +grub, then you will need to edit the commands accordingly.) Reset +your PC and take the floppy disk out of the drive. The hard disk +should now boot successfully. Select the single-user boot menu option, and proceed to STEP VI. -- cgit v1.2.3